Synthetic thermally reversible gel systems. V

Differential thermal analysis has been used to study the fusion of aqueous thermally reversible gels of gelatin and polyacrylylglycinamide (PAG). In the case of gelatin gels, endotherms close to the melting point are readily observed and these are sometimes preceeded by a small exothermic heat of gel reorganization. Calculations are presented to show that breaking of the gelatin gel network requires only a small fraction of the observed endothermic heat of fusion and that most of the heat is required for melting larger crystallites within gelatin aggregates and for perhaps a helix → coil transition. Failure to observe endotherms by DTA over the known temperature range of fusion of PAG gels is consistent with prior measurements and conclusions. The noncrystallinity of PAG gels and soluble aggregates together with a heat of crosslinking of only ?5 to ?10 kcal/mole of crosslinks places the heat of fusion of PAG gels outside the lower limits of DTA sensitivity.     

Gas chromatographic optimization studies on the side chain and ring regioisomers of methylenedioxymethamphetamine

Gas chromatographic (GC) optimization studies are conducted for the 10 methylenedioxyphenethylamine regioisomeric substances related to the drug of abuse 3,4-methylenedioxymethamphetamine (MDMA, Ecstasy). These 10 compounds, having the same molecular weight and equivalent major mass spectral fragments, are not completely resolved using typical GC-mass spectrometry screening methods for illicit drugs. MDMA coelutes with at least one nondrug regioisomer under standard drug screening conditions. Separation of the 10 regioisomers is studied using stationary phases of varying polarities. Resolution optimization shows that very slow program rates give the best separation for the nonpolar stationary phases, requiring analysis times of as much as 85 min. Narrow-bore columns containing the same nonpolar stationary phases improve the analysis time to approximately 29 min. The polar stationary phase DB-35MS allows high-temperature programming rates, yielding complete resolution of all 10 compounds in less than 7 min. Temperature program optimization studies on the DB-35MS phase allow the separation time to be reduced to approximately 4.5 min.     

Molecular structures and intramolecular interactions in dimethyl cyclohexane isomers

The geometries of ten isomers of dimethyl cyclohexane were determined by ab initio gradient geometry refinement with the 4-21G basis set. It is found that many intramolecular interactions are clearly manifested by correlated structural trends, and that they are consistent with strain energies calculated by employing previously defined ab initio group equivalents. Specifically, non-bonded interactions are found between two adjacent methyl groups in some of the forms, and between axial methyl groups and adjacent axial C? H bonds in others. Unperturbed axial C? H and C? C bonds are consistently longer than equatorial bonds. In general, C? H bonds which are involved in non-bonded repulsive interactions are shortened, i.e., strengthened, and the corresponding H? C? C angles are large, compared to non-interacting parameters.     

The identification of 10 and 11 substituted 7H-benzimidazo[2,1-a]benz[de]isoquinolin-7-ones through 1N NOE studies on their methyl p-toluenesulfonate salts

The spectral similarities of 10 and 11 substituted 7H-benzimidazo[2,1-a]benz[de]isoquinolin-7-ones hinder the identification of the individual isomers. Preparation of the 13-methyl p-toluenesulfonate salts of these compounds has allowed the assignment by the use of NOE techniques. Saturation of the N-methyl caused an NOE at H-12. The coupling pattern of H-12 then provides identification of the compound.     

Synthesis of mixed metal decaosmium carbido clusters: The X-ray structures of the monoanions [Os10C(CO)24Cu(NCMe)]− and [Os10C(CO)24AuPPh3]−

The high nuclearity mixed metal cluster monoanions [Os₁₀C(CO)₂₄Cu(NCMe)]^? (I) and [Os₁₀C(CO)₂₄AuPPh₃]^? (II) have been obtained by reaction of the carbido-dianion [Os₁₀C(CO)₂₄]^2? (III) with one equivalent of [Cu(NCMe)₄] [BF₄] and Ph₃PAuCl, respectively, in CH₂Cl₂. X-ray analysis of the [PPh₃Me]⁺ salts of I and II show that the Cu and Au ligands have added to capping tetrahedra of the dianion III in μ₃- and μ₂-bridging positions, respectively.     

Pyrimidines. XIII. Novel pyrimidine to pyrimidine transformation reactions

Novel pyrimidine to pyrimidine transformation reactions are described. 1,3-Dimethyl-(or diethyl)-uracil(1) are converted into isocytosine, 2-thiouracil or uracil derivatives by treatment with guanidine, thiourea or urea, respectively. The latter two cases require base catalysis. The effects of some substituents at C-5 and C-6 of 1,3-dialkylated uracils (1a → 1e) on this transformation were examined and a plausible mechanism is offered for their reaction. The utility of this reaction is exemplified by the facile two-step conversion of pseudouridine into the anlileukemic agent, pseudoisocytidine, in good overall yield.     

Photoinduced axial ligation and deligation dynamics of nonplanar nickel dodecaarylporphyrins

The ground- and excited-state metal-ligand dynamics of nonplanar nickel(II) 2,3,5,7,8,10,12,13,15,17,18,20-dodecaphenylporphyrin (NiDPP) and two fluorinated analogues (NiF(20)DPP and NiF(28)DPP) have been investigated using static and time-resolved absorption spectroscopy in toluene and in ligating media that differ in basicity, aromaticity, and steric encumbrance. Because of the electronic and steric consequences of nonplanarity, NiDPP does not bind axial ligands in the ground state, but metal coordination does occur after photoexcitation with multistep dynamics that depend on the properties of the ligand. Following the structural relaxations that occur in all nickel porphyrins within approximately 10 ps, ligand binding to photoexcited NiDPP is progressively longer in pyridine, piperidine, and 3,5-lutidine (25-100 ps) but does not occur at all in 2,6-lutidine in which the ligating nitrogen is sterically encumbered. The transient intermediate that is formed, which nominally could be either a five- or six-coordinate species, also has a ligand-dependent lifetime (200-550 ps). Decay of this intermediate occurs partially via ligand release to re-form the uncoordinated species, in competition with binding of the second axial ligand and/or conformational/electronic relaxations (of a six-coordinate intermediate) to give the ground state of the bis-ligated photoproduct. The finding that the photoproduct channel principally depends on ligand characteristics along with the time-evolving spectra suggests that the transient intermediate may involve a five-coordinate species. In contrast to NiDPP, the fluorinated analogues NiF(20)DPP and NiF(28)DPP do coordinate axial ligands in the ground state but eject them after photoexcitation. Collectively, these results demonstrate the sensitivity with which the electronic and structural characteristics of the macrocycle, substituents, and solvent (ligands) can govern the photophysical and photochemical properties of nonplanar porphyrins and open new avenues for exploring photoinduced ligand association and dissociation behavior.     

Vitamin B12 as an allosteric cofactor; dual fluorescence, hysteresis, oscillations and the selection of corrin over porphyrin

Studies of the emission spectra of four Co(III) cobinamides (diaquo-, aquohydroxo-, dihydroxo- and dicyano-) show (1) that the excited states corresponding to the alphabeta and epsilon absorption bands behave like the S(1) and S(2) levels in the non-alternant hydrocarbon azulene (with emission from S(2)> S(1) in violation of Kasha's rule) and (2) that the excited states include a TICT (twisted intramolecular charge transfer) mechanism, as in the simpler cyanines, but where the TICT state gives rise to dual fluorescence instead of cis-trans isomerisation. Combined with the previously reported dual fluorescence from the S(1) level in synthetic metal corrinoids and in the naturally-occurring metal-free corrin, this provides evidence that the existence of an additional (metastable) ground state with a significantly different vibronic splitting and nuclear configuration is an intrinsic property of the basic corrin ligand (irrespective of the nature of the side-chains and the metal ion or even the absence of a metal) which distinguishes it from porphyrin. The occurrence of hysteresis (and its associated oscillations) in redox reactions of the cobinamides involving both the Co(III/II) and Co(II/I) couples indicates that the corrin ligand also has an intrinsic ability to exist in different conformations or "allosteric" forms with differing redox potential, which further distinguishes it from the porphyrin ligand. Possible links between the existence of an additional metastable ground state and of allosteric changes and the likely reasons for the selection of corrin over a porphyrin for the vitamin B(12)-dependent enzymes are discussed.     

Products of the reaction of H2Os3(CO)10 with cyclonona-1,2diene

Treatment of H₂Os₃(CO)₁₀ with cyclonona-l,2-diene produced HOs₃(CO)₉C₉H₁₃ and Os₂(CO)₆(C₉H₄)₂. Single crystal X ray analysis has shown that the latter is not isostructural with Fe₂(CO)₆(C₉H₁₄)₂.     

The Catalytic Oxidative Coupling of Methane

One of the great challenges in the field of heterogeneous catalysis is the conversion of methane to more useful chemicals and fuels. A chemical of particular importance is ethene, which can be obtained by the oxidative coupling of methane. In this reaction CH₄ is first oxidatively converted into C₂H₆, and then into C₂H₄. The fundamental aspects of the problem involve both a heterogeneous component, which includes the activation of CH₄ on a metal oxide surface, and a homogeneous gas-phase component, which includes free-radical chemistry. Ethane is produced mainly by the coupling of the surface-generated CH radicals in the gas phase. The yield of C₂H₄ and C₂H₆ is limited by secondary reactions of CH radicals with the surface and by the further oxidation of C₂H₄, both on the catalyst surface and in the gas phase. Currently, the best catalysts provide 20% CH₄ conversion with 80% combined C₂H₄ and C₂H₆ selectivity in a single pass through the reactor. Less is known about the nature of the active centers than about the reaction mechanism; however, reactive oxygen ions are apparently required for the activation of CH₄ on certain catalysts. There is spectroscopic evidence for surface O^? or O ions. In addition to the oxidative coupling of CH₄, cross-coupling reactions, such as between methane and toluene to produce styrene, have been investigated. Many of the same catalysts are effective, and the cross-coupling reaction also appears to involve surface-generated radicals. Although a technological process has not been developed, extensive research has resulted in a reasonable understanding of the elementary reactions that occur during the oxidative coupling of methane.